ECscan20/30/40
Overview
Thank you for selecting the ECscan series pocket conductivity tester. This manual provides a step-by-step guide to help you operate the instrument,
please carefully read the following instructions according to the model you have purchased.
Installing the Batteries
1.
Twist the electrode collar counter clockwise, pull the electrode away from the tester.
2.
Insert the two AAA batteries into the battery compartment, note polarity.
3.
Push the electrode into the tester and twist the electrode collar clockwise until tight.
Keypad
Key
Function
•
Switch the tester on or off
• Lock the reading, press the key again to
resume measurement
• Exit the calibration
, setting and return to the measurement mode
• Start calibration
•
Press and hold key to enter the setup menu
•
Select an option
•
Confirm the calibration, setting or displayed option
•
Toggle between available measurement modes (only for ECscan30 and 40 testers)
Display
Icon
Description
When the battery voltage falls below the minimum power requirements, the icon automatically disappears
MEAS
Indicates that the tester is in the measurement mode
CAL
Indicates that the tester is in the calibration mode
SETUP
Indicates that the tester is in the setup mode
ATC
Indicates that the automatic temperature compensation is enabled
Prior to Use
•
Remove the protective cap and translucent cover from the bottom of the tester.
•
If the platinum sensor has dried out, soak the electrode for a few minutes in tap water.
Platinum sensor