Cellular Kit Model
Kit Description
SXI-CATM1VZW-001
Verizon CAT M1 cellular modem using Telit ME910 modem kit (Verizon part number SXIM1V). Includes a cellular modem, SIM card,
and internal adhesive antenna. The SIM card is specific to the CATM1 technology and cannot be used in other cellular modems.
Requires a LTE Verizon cellular wireless plan attached to the ICCID (SIM card) number and IMEI (International Mobile Equipment
Identity) number.
Cellular plans can be purchased through
.
SXI-CATM1ATT-001
ATT CAT M1 cellular modem using Telit ME910 model kit. (ATT part number SXIM1A). Includes a cellular modem, SIM card. and
internal adhesive antenna. The SIM card is specific to the CATM1 technology and cannot be used in other cellular modems. Requires
a LTE AT&T cellular wireless plan attached to the ICCID (SIM card) number and IMEI (International Mobile Equipment Identity) number.
Cellular plans can be purchased through
.
1
2
3
Figure 4. Installing the cellular modem
1. Insert the SIM card into the socket on the underside of the cellular modem. SIM cards come in a credit card sized carrier.
Snap it out and insert the SIM card into the holder on the cellular modem.
Make note of the IMEI number of the cellular modem and the ICCID number of the SIM card. The numbers can be found on
the cellular modem and the SIM card or SIM card carrier. You will need the SIM number to associate a wireless plan to this
SIM card.
2. Apply the internal antenna as shown paying attention to the antenna cable position.
a) Pull back the adhesive protective paper from the middle of the antenna, only exposing the middle portion. Antenna
application is easier if just a small middle portion of the adhesive is uncovered.
b) Center the antenna on the side wall. Use the exposed adhesive in the middle of the antenna to hold the antenna in
place while aligning the antenna to the full length of the housing.
c) Slowly peel off the paper backing exposing the adhesive and stick to the plastic housing. The antenna should run
below the rim of the housing.
d) Press firmly.
3. Orient the cellular modem according to the diagram below and verify the pins are properly aligned. Firmly press the modem
into the 24-pin socket on the board.
The cellular modem is inserted into the main board with the antenna cable from the applied internal antenna attached to
the cellular modem PCB.
4. Attach the antenna cable between the cellular modem board to the base board. The antenna cable uses the top antenna
connection.
*SIM card is located on the underside of installed modem
Cell Modem
Antenna Cable
SIM card*
location
Micro USB
ISM
Radio
Board
Cellular Antenna Placement
Figure 5. Internal view of a DXM1200
Install and Activate a Cellular Modem
P/N 205026 Rev. D
www.bannerengineering.com - Tel: + 1 888 373 6767
3
