The LCD displays the text shown. While
Channel Search Mode runs, LED 1 is solid
red and LED 2 flashes yellow.
The device tests Network ID 2 for availability
and counts down from one minute, zero
seconds.
The selected Network ID is available for use.
LED 1 is solid red, LED 2 is solid yellow.
START
CHANNL
SEARCH
MODE
SEARCH
NID 2
1M 0S
Is the NID in
use?
No
Yes
NID OK
RUN
CUR 2
NEW 2
Select new NID
Single click
button 2
IGNORE
Double click
button 2
ABORT
Double click
button 2
Apply power
to the Gateway
To cancel Channel
Search Mode
To ignore Channel
Search Mode results
Applying Power to the Gateway or Node
Wire Color
Gateway (10 to 30V
dc)
Node (10 to 30V dc)
Node (FlexPower
™
)
1
2
3
4
5
1
brown
+10 to 30V dc input
10 to 30V dc
2
white
RS485 / D1 / B / +
3
blue
dc common (GND)
dc common (GND)
dc common (GND)
4
black
RS485 / D0 / A / -
5
gray
Comms gnd
3.6 to 5.5V dc*
* Do not apply more than 5.5V dc to the gray wire.
1. Apply power to the Gateway by connecting the 10 to 30V dc cable as shown.
The Gateway begins in RUN mode, displays the current network ID (NID), then identifies itself as a Gateway.
2. Apply power to the Node by connecting the 10 to 30V dc cable or the DX81 Battery Supply Module as shown. To apply power to a
FlexPower Node with an integrated battery, install the battery into the housing.
The Node starts in RUN mode, displays the current network ID, then identifies itself as a Node and lists its device ID.
SureCross Wireless I/O Network Manual
rev. I
www.bannerengineering.com - tel: 763-544-3164
57
