1
2
3
4
5
1. Housing. The rugged, industrial DX80 housing meets IEC IP67
standards.
2. Mounting hold, #10/M5 clearance. Mounting Holes accept metric
M5 or UNC/UNF #10 hardware -- DIN rail mount adapter bracket avail-
able.
3. Wiring terminal strip. The 16 spring-clip type wiring terminals accept
wire sizes: AWG 12-28 or 2.5 sq mm.
4. Port, PG-7 gland or blank. The PG-7 threaded ports can accept pro-
vided cable glands or blanks.
5. Ribbon connector. Ribbon cable connects wiring base to LCD/radio.
The GatewayPro has no serviceable parts inside the housing and no wiring chamber. During setup or standard operation, there should
not be a need to open the GatewayPro.
DX80 GatewayPro
The GatewayPro has many of the same features as the Gateway and Node, including the LEDs, the buttons, LCD, and Euro-style con-
nector.
1
Industrial ethernet port, female.
2
Rotary switch 1 (left). Sets the Network ID (NID) to a hexidecimal value
from 0 to F, for a total of 16 Network IDs. A Gateway and its corresponding
Nodes must be assigned the same Network ID.
Rotary switch 2 (right). On the Gateway, sets the Gateway’s LCD viewing
device address. The Gateway is predefined as Device Address 0. On the
Node, sets the Node’s Device Address (hexidecimal 1 to F). Each Node
within a network must have a unique Node Device Address.
3
Push button 1. Single-click to advance across all top-level DX80 menus.
Single-click to move down interactive menus, once a top-level menu is
chosen.
4
Push button 2. Double-click to select a menu and to enter manual scrolling
mode. Double-click to move up one level at a time.
5
LED 1 and 2. Provide real-time feedback to the user regarding RF link sta-
tus, serial communications activity, and the error state.
6
LCD Display. Six-character display provides run mode user information
and shows enabled I/O point status. This display allows the user to con-
duct a Site Survey (RSSI) and modify other DX80 configuration parame-
ters without the use of a PC or other external software interfaces. On the
Node, after 15 minutes of inactivity, the LCD goes blank. Press any button
to refresh the display.
7
5-pin M12 Euro-style quick disconnect serial port.
DX83 Ethernet Bridge
The DX83 Ethernet Bridge uses the same housing and same mounting holes as the Gateway and Node.
SureCross Wireless I/O Network Manual
10
www.bannerengineering.com - tel: 763-544-3164
rev. I
