Discrete Inputs
Rating: 3 mA max current at 30 V dc
Sample Rate: 40 milliseconds
ON Condition (NPN): Less than 0.7 V
OFF Condition (NPN): Greater than 2 V or open
Thermocouple Inputs (MultiHop)
Sample Rate: 8 seconds
Accuracy: 0.1% of full scale r 0.8 °C
0.1 °C, 24-bit A/D converter
Thermistor Input (MultiHop)
Model: Omega’s 44006 or 44031 family of 10 kOhm thermistors
Sample Rate: 1 second
Accuracy: 0.4 °C (10 °C to 50 °C); Up to 0.8 °C (−40 °C to 85 °C)
Thermocouple Notes
Each thermocouple input must be isolated from ground and shielded for proper
operation.
Discrete Outputs
ON Condition: Less than 0.7 V
OFF Condition: Open
Discrete Output Rating (MultiHop NMOS)
Less than 1 A max current at 30 V dc
ON-State Saturation: Less than 0.7 V at 20 mA
Certifications
Environmental Specifications for the E Housing
Operating Conditions
–40 °C to +85 °C (–40 °F to +185 °F) (Electronics); –20 °C to +80 °C (–4 °F to +176 °F)
(LCD)
95% maximum relative humidity (non-condensing)
Radiated Immunity: 10 V/m (EN 61000-4-3)
Shock and Vibration
IEC 68-2-6 and IEC 68-2-27
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration: 0.5 mm p-p, 10 to 60 Hz
Environmental Ratings
IEC IP65
Refer to the Sure Cross
®
MultiHop Product Instruction Manual (p/n
installation and waterproofing instructions.
Operating the devices at the maximum operating conditions for extended
periods can shorten the life of the device.
Accessories
Thermistor Probes
BWA-THERMISTOR-PROBE-001
•
Temperature sensor with thermistor PS103G2
•
Beta Value(K) 0 ~50°C: 3575
•
Base thermistor accuracy of 0.2%
•
Operating Temperature Range: –20 °C to +105 °C
•
Maximum Power Rating: 30 mW at 25 °C; derated to 1 mW at 125 °C
•
Dissipation Constant: 1 mW/°C
•
Plated nickel finish; PVC insulation
( 3.2 )
35 mm
6 mm
( 4)
20 mm
72 mm
Tube
Included with the DX80..E Models
• Mounting hardware kit
• BWA-HW-003: PTFE tape
• BWA-9O2-C (900 MHz) or BWA-2O2-C (2.4 GHz): Antenna, 2 dBd Omni, Rubber Swivel RP-SMA Male. (Not included with Internal antenna
models)
• BWA-BATT-001: Replacement battery, 3.6 Volt, "D" Lithium Cell
• BWA-HW-032: Access Hardware for "E" Housing (One each of 1/2-inch plug, 1/2-inch gland)
• Product datasheet and product family Quick Start Guide (
Warnings
Install and properly ground a qualified surge suppressor when installing a remote antenna system. Remote antenna configurations installed without surge suppressors invalidate the manufacturer's warranty. Keep
the ground wire as short as possible and make all ground connections to a single-point ground system to ensure no ground loops are created. No surge suppressor can absorb all lightning strikes; do not touch
the Sure Cross
®
device or any equipment connected to the Sure Cross device during a thunderstorm.
Exporting Sure Cross
®
Radios. It is our intent to fully comply with all national and regional regulations regarding radio frequency emissions. Customers who want to re-export this product to a country other than
that to which it was sold must ensure the device is approved in the destination country. A list of approved countries appears in the
Radio Certifications
section of the product manual. The Sure Cross wireless
products were certified for use in these countries using the antenna that ships with the product. When using other antennas, verify you are not exceeding the transmit power levels allowed by local governing
agencies. Consult with Banner Engineering Corp. if the destination country is not on this list.
Sure Cross
®
MultiHop H3E-NB-KR Data Radio
P/N 209529 Rev. A
www.bannerengineering.com - Tel: + 1 888 373 6767
7
