Step 1. Open the end with the glass window (5) and gently
lift
the radio core unit (4) and the space frame it sits on up. The core unit
connects to the space frame using two pins and the radio core is connected to the wiring board with a ribbon cable.
Step 2. Disconnect the ribbon cable from the radio.
Step 3. Insert the
battery
(2) into the
battery
holder, verifying the
position
and
negative
poles of the
battery
are
positioned
according to
the markings on the board.
Step 4. Install the terminal header (3) onto the terminal pins.
Step 5. Insert your sensor wires through a cable gland and one of the two 1/2-inch NPT ports. Wire the sensor wires into the terminal
header (3) according to the control drawings, p/n 141513. Use a cable gland
certified
for your region and environment. For a waterproof
seal, refer to the
waterproofing
instructions
in Banner document 132607.
7
1
2
3
5
6
4
Figure 2. Installing and
Connecting
the Antenna
Step 6. To install the dome antenna (2), thread the antenna cable through the 1/2-inch NPT port and screw the dome antenna to the
1/2-inch NPT port.
Step 7. Connect the antenna cable (3) to the radio unit’s antenna connector (5). (You may need to separate the space frame from the
radio to do this.)
Step 8. Gently install the ribbon cable (4) into the ribbon cable pins (6), verifying the ribbon cable is seated on both rows of pins.
Step 9. Reconnect the space frame (not shown) to the radio core unit.
Step 10. Place the radio unit into the housing and gently push down
until
the spacer frame pin holes rest on the edge of the metal
housing.
Figure 3. Final Assembly
Step 11. Close the metal cover
firmly
and lock closed using the set screw.
Installing or Replacing the
Battery
(DX99...D Models)
To install or replace the lithium "D" cell
battery
in the metal housings, follow these steps.
1. Unscrew the lid of the metal enclosure.
2.
Lift
the radio out of the metal enclosure and pull the spacer frame
off
the back side of the radio.
3. Disconnect the radio by unplugging the ribbon cable from the radio board and set aside the radio and spacer frame.
Sure Cross
®
DX99 FlexPower Thermocouple Node (Metal Housing)
P/N 142681 Rev. O
www.bannerengineering.com - Tel: +1-763-544-3164
7
