Specifications
Supply Voltage and Current
10 to 30V dc (10% max. ripple at 10% duty cycle) at 35
mA max current, exclusive of load
Sensing Beam
Visible red LED, 650 nm
Laser Classification
Class 1
Beam Size at Aperture
Approx. 3 mm
Supply Protection Circuitry
Protected against reverse polarity, over voltage, and
transient voltages
Delay at Power-Up
1 second max.; outputs do not conduct during this time
Output Configuration
Solid-state bipolar (SPDT): 1 current sourcing (PNP)
and 1 current sinking (NPN)
Rating: 150 mA maximum load
Off-state leakage current: < 10 µA at 30V dc
ON-state saturation voltage:
• NPN: less than 1.0V at 150 mA load
• PNP: less than 2.0V at 150 mA load
Output Protection Circuitry
Protected against output short-circuit, continuous over-
load, transient over-voltages, and false pulse on pow-
er-up
Output Response
500 microseconds
Repeatability
70 microseconds
Adjustments
2 push buttons and remote wire
• Easy push-button configuration
• Manually adjust (+/-) thresholds (push buttons only)
• LO/DO and OFF-delay configuration options
• Push-button lockout (from remote wire only)
Factory Defaults:
• No Delay
• Dark Operate
• Push buttons enabled
Indicators
Output conducting
8-Segment Red Bargraph
SETUP mode:
• Flashes Red when delay is selected
• Flashes Red when Dark Operate is selected
• Flashes Red when Light Operate is selected
RUN mode:
Model QS30LLP
Model QS30LLPC
LED 8: >6X
LED 8: >2X
LED 7: 5-6X
LED 7: 1.5-2X
LED 6: 4-5X
LED 6: 1-1.5X
LED 5: 3-4X
LED 5: 0.8X
LED 4: 2-3X
LED 4: 0.6X
LED 3: 1-2X
LED 3: 0.4X
LED 2: 0.5-1X
LED 2: 0.2X
LED 1: 0-0.5X
LED 1: 0X
Sensor calibration failure:
Construction
Environmental Rating
IEC IP67; NEMA 6
Connections
5-conductor 2 m (6.5 ft) PVC cable, 9 m (30 ft) PVC ca-
ble, or 5-pin integral Euro-style quick-disconnect fitting
Operating Conditions
Temp: –10° to +50° C (+14° to 122° F)
Relative Humidity: 90% at 50° C (non-condensing)
Vibration and Mechanical Shock
All models meet Mil. Std. 202F requirements. Method
201A (Vibration: 10 to 60Hz max. double amplitude
0.06 in, maximum acceleration 10G). Also meets IEC
947-5-2 requirements: 30G, 11 ms duration, half sine
wave.
Certifications
WORLD-BEAM QS30 LLP and LLPC
8
www.bannerengineering.com - tel: 763-544-3164
P/N 112355 Rev. C
