Banner EZ-SCREEN SLS, Instruction Manual

Page: 57 / 114

May 22, 2023
EZ-SCREEN SLS Safety Light Curtain Instruction Manual
57
•
•
•
•
•
•
•
•
Key Description
A
Status Indicator (Red/Green)—shows whether power is applied and whether
the emitter is in Run mode, TEST mode, or Lockout condition.
A
B
B 1-digit Diagnostic Display—indicates specific error or configuration conditions.
Key Description
A
Reset indicator (Yellow)—shows System status:
Run mode (ON)
Waiting for a reset (flashing)
A
D
E
B
C
B
Status indicator (Red/Green)—shows System status:
Reduced Resolution enabled (flashing green)
Outputs are ON or OFF (green ON or red ON)
The System is in Lockout condition (flashing red)
C
3-Digit Diagnostic Display—indicates specific error, configuration conditions, or
total number of blocked beams.
D
Zone indicators (Red/Green)—each shows status of approximately 1/8 of the
total beams:
Aligned and clear (green ON)
Blocked and/or misaligned (red ON)
Fixed blanked area (flashing green)
E Zone 1 Indicator—indicates beam synchronization status
A single bi-color red/green Status indicator shows whether power is applied, and whether the emitter is in Run mode optional
Test mode, or Lockout status. A Diagnostic Display indicates a specific error code when the emitter is in Lockout; the display
also momentarily indicates the scan code setting at power-up or when changed.
Operating Sta-
tus
Required Event Status Indicator Diagnostic Display
Power-up Apply Power Red single-flash
Scan code flash 3 times, alternates then or then
Run Mode
Passes internal
tests
Green
Test Mode Open Test switch Flashing green
Lockout
Internal/external
fault
Flashing red Displays error code (see "Troubleshooting" on page 85 )
Emitter
Table 5.
Emitter
Figure 30.
Receiver Table 6.
Receiver
Figure 31.
Emitter Status Indicators
6.4.1
© Banner Engineering Corp.