RUN/PRG/ADJ Mode Switch
The RUN/PRG/ADJ mode switch puts the sensor in RUN, PRG (Program), or ADJ (Adjust) mode. RUN mode allows
the sensor to operate normally and prevents unintentional programming changes via the +/SET/- button. PRG mode
allows the sensor to be programmed through the display driven programming menu (see Program Mode below).
ADJ mode allows the user to perform Expert TEACH/SET methods and Manual Adjust (see Adjust Mode below).
LO/DO Switch
The LO/DO switch is used to select Light Operate or Dark Operate mode. In Light Operate mode, the output is ON
when the sensing condition is above the threshold (for Window SET, the output is ON when the sensing condition is
inside the window). In Dark Operate mode, the output is ON when the sensing condition is below the threshold (for
Window SET, the output is ON when the sensing condition is outside the window).
+/SET/- Rocker Button
The +/SET/- rocker button is a 3-way button. The +/- positions are engaged by rocking the button left/right. The SET
position is engaged by clicking down the button while the rocker is in the middle position. All three button positions
are used during PRG mode to navigate the display driven programming menu. During ADJ mode, SET is used to
perform TEACH/SET methods and +/- are used to manually adjust the threshold(s). The rocker button is disabled
during RUN mode, except when using Window SET, see
Window SET
on page 6.
Red/Green Digital Displays
During RUN and ADJ mode, the Red display shows the signal level and the Green display shows the threshold.
During PRG mode, both displays are used to navigate the display driven programming menu.
Output LED
The output LED provides a visible indication when the output is activated.
Operating Instructions
Remote Input/IO-Link
For more information about how to perform TEACH/SET methods, to program the sensor remotely, or to interface with the sensor
via IO-Link, see the DF-G1 Manual (P/N 161999).
Run Mode
Run mode allows the sensor to operate normally and prevents unintentional programming changes. The +/SET/- rocker button is
disabled during RUN mode, except when using Window SET.
DF-G1 Expert
™
Dual Display Fiber Amplifier
4
www.bannerengineering.com - Tel: + 1 888 373 6767
P/N 161275 Rev. E
