14. Click the Focus Calibration tab at the bottom of the window.
Note: This feature is only available for manual focus models.
The oscilloscope view is shown in the bottom panel and can be used for manual focus adjustment.
Figure 60. Oscilloscope View
The red line in the image panel above the oscilloscope must pass through the code. Click and drag the red line
vertically to reposition it over the code.
Note: To enlarge the visual image of the code and the oscilloscope views, drag the Focus
Calibration window up and click the zoom image
icon repositioning it on the code.
While in run mode, manually adjust the focus until the bars relative to the code in the oscilloscope demonstrate their
maximum length (focus).
You can also see the visual focus on the code view.
Figure 61. Code View and Oscilliscope View Zoomed In
When focused, click
Pause to stop image acquisition.
ABR 7000 Series Barcode Reader
www.bannerengineering.com - Tel: + 1 888 373 6767
49