banks Banks Split-Dual Monster F250, Owner'S Manual, Page: 8 / 16

10.
Install the Y-pipe over the
intermediate pipe as shown in
Figure 1
. Install clamps onto each
Y-pipe outlet.
11.
Locate the two slots on the rear
diverside frame rail and install the
supplied Banks hanger bracket using
the supplied hardware. Be sure the
hanger pin is align parallel to the frame
rail and torque the hardware to 48ft-lb.
See Figure 4 .
12.
Install the supplied rubber
insulator onto the Banks hanger
bracket.
13.
Install the driver-side tailpipe onto
the left Y-pipe outlet. Install the driver-
side tailpipe hanger into the vehicle
rubber insulator. Position the rubber
insulator as shown in
Figure 5
.
14.
Install the passenger-side tailpipe
onto the right Y-pipe outlet. Install the
passenger-side tailpipe hanger into the
vehicle rubber insulator. Position the
rubber insulator as shown in
Figure 3
.
15.
Loosen and move the spare-tire
to the rear of the vehicle and center
between the dual tailpipes. Securely
tighten the spare tire so that it is
retained in place see Figure 6 .
FACTORY
LEAF STOP
BANKS
HANGER
BRACKET
FACTORY
FRAME
SLOT
BANKS
RUBBER
INSULATOR
BANKS
7/16”
HARDWARE
BANKS
DRIVER SIDE
TAILPIPE
FORWARD
Figure 4
8
96547 v.1.0