Alternative Setup
29
Stereo setup - Left & Right
Initial setup
The BeoSound Shape can be used in a normal stereo setup. The setup will
not
have ' Band on the Wall' effect. This can e.g. be useful when the
BeoSound Shape is used as rear speakers. In the following stereo setup, no Design ID is used; instead the standard filter is used. Daisy chaining to
other amplifiers is not possible when using standard filters.
Note! The amplifier must always be placed without a tile underneath.
Amplifier tiles are delivered as 'slaves' from factory. The amplifier must be set as 'Master' if it is used in a stereo setup. To set up the amplifier, a
BeoSound Core must be connected.
To load the standard filter into the amplifier tile, the tile has to be converted to master mode. Follow these steps:
- Connect the amplifier tile to a factory reset BeoSound Core.
- Connect the BeoSound Core to the amplifier tile by using the USB connection.
- Power up both units.
- When the BeoSound Core is booting up, it will update the amplifier tile to be in the master mode and load in the standard sound filter.
- After the update is done, the amplifier tile will shortly light up in white colour which indicates master mode. Do not remove the BeoSound Core
before this light is seen.
- If no white light is seen within 5 minutes, make a factory reset of the BeoSound Core to restart the process.
POWER
LINE-IN/OPTICAL
OPTICAL OUT
ETHERNET
DPL
POWER LINK
5V 0.5A
USB B
USB A
CO
MM
OUT
CO
MM
IN
OP
TIC
AL-
IN
PO
WE
R L
INK
SLAVE MODE
MASTER MODE
LED Indicator
