2.1
Explanation of diagram
Explanation of diagram
Type numbers of transistors and ICs are indicated on the diagrams. If the position
is followed by an asterisk the spare part number must always be used because the
component in question has been specially selected, e.g. TR102*.
Component print and coordinate system
The largest PCBs have component prints and a coordinate system on both the print
and the component side.
On the diagrams every component has a coordinate number. This indicates in which
coordinate on the PCB the component is situated. The coordinate numbers are
written in smaller print types than the position numbers.
Control circuit
In certain control circuits the active mode is indicated by a function term or by an
abbreviation. This may be e.g. ST.BY. = low in the stand-by mode or ST.BY. = high
in the stand-by mode.
Wiring connections
The wiring connections on the diagrams are assembled in ‘bundles’. The individual
wires are provided with one of the following codes:
INTERNAL CONNECTION ON ONE DIAGRAM PAGE
Internal connections on a diagram page are indicated by a number.
The bend of the wire indicates in wich direction the other end of the wire is found.
CONNECTION TO ANOTHER DIAGRAM PAGE
A connection to another diagram page is indicated by a number as well as by a
letter of the diagram to which the connection leads.
Supply Voltages
All supply voltages in the diagrams are indicated by an arrow and a voltage indication.
Ground symbols
Three different ground symbols are used in the set.
= RF - OSC - SH - IF1 - IF2 - A
= Chassis
= D
Symbol of safety components
When replacing components with this symbol, components with identical part
numbers must be used. The new component must be mounted in the same way
as the one replaced.
12
12
20
20
C3
C32
A32
A3
DIAGRAM A
DIAGRAM C
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK