11
Adapt BeoLab 5 to your system
The loudspeaker is set to
Option
number 0 from the factory.
Therefore, when you connect the
loudspeaker to a Bang & Olufsen
audio or video system, it is not
necessary to change the
Option
setting. In this case, the loudspeakers
are controlled via the Bang & Olufsen
system.
However, when the loudspeaker is
connected to a non-Bang & Olufsen
system, you must change the
Option
setting. In this case, the Beo4 remote
control signals are received and
processed by the loudspeakers. Two
different
Option
settings are available
– which to use depends on your
setup.
If the LINE output level of your
non-Bang & Olufsen system exceeds
2 V RMS, you must set the loudspeakers to
accommodate a higher input level
(> 2 V RMS
≤
4 V RMS).
Option 0
Option 1
Option 4
Option 0
(factory setup): Used if connected to a
Bang & Olufsen audio (or video) system.
Option 1:
Used if connected to a non-Bang &
Olufsen system. You may have a Bang & Olufsen
television in the same room, if you wish.
Option 4:
Used if connected to a non-Bang &
Olufsen system – and you have an extra Bang &
Olufsen audio system in the same room.
A Beo4 remote control is used to change the
‘Option’ and the LINE input level setting.
To change the
Option
setting:
> While holding down the • button, press
LIST
.
> Let go of both buttons.
> Press
LIST
repeatedly until OPTION? is shown in
the Beo4 display.
> Press
GO
.
> Press
LIST
repeatedly until L.OPT is shown in the
Beo4 display.
> Key in the appropriate Option number (
0
,
1
or
4
).
The indicator light switches off briefly, confirming
that the new
Option
number has been stored.
To
ensure that all loudspeakers are programmed to
the correct number, repeat the procedure for each
loudspeaker separately.
To change the LINE input level setting:
> Press
LIST
repeatedly until SOUND* is shown in
the Beo4 display.
> Press
GO
.
> Key in the appropriate LINE input level number
(
1
if LINE input level < 2 V RMS;
2
if LINE input
level > 2 V RMS
≤
4 V RMS).
The indicator light switches off briefly, confirming
that the new LINE input level has been stored.
To
ensure that all loudspeakers are set to the same
LINE input level, repeat the procedure for each
loudspeaker separately.
*Must be added to the Beo4 LIST-function. To do
so, refer to the Beo4 Guide.
Summary of Contents for BeoLab 5
Page 1: ...BeoLab 5 Guide...
Page 20: ......