Set up the loudspeaker – cable connections
The loudspeaker socket panel is
located on the rear. Insert the
cables and set the POSITION
switch before you fasten the
loudspeaker to the wall bracket.
For information about the
sockets on the Bang & Olufsen
system, refer to the Guides
enclosed with the product.
Before you make any connections,
disconnect your Bang & Olufsen
system from the mains supply!
POWER LINK socket:
Use this
socket to connect the loudspeaker
to one of the Power Link sockets
on the Bang & Olufsen system.
Note: Do not use a Power Link
cable of the older type, as this will
cause noise, and therefore not give
optimum sound quality! The new
type has a triangular mark on the
plug.
Cable clamp:
For safety reasons,
the mains cord from the wall outlet
must be secured to the loud
speaker. To do so, tug the cord
behind the cable clamp.
Power Link
Mk 3
4
POWER LINK
socket
POSITION switch
Cable clamp
Summary of Contents for BeoLab 10
Page 1: ...BeoLab 10 Guide...
