B&R Power Panel T30, User Manual

Page: 79 / 140

Configuration • Service pages
Power Panel T30 User's manual V1.42 - Translation of the original documentation 79
5.1.11.1 Configuring the update server
The following figure shows the default settings for configuring the update server on the
Update
service page:
VNC
Web
Storage
Update
Backup & Reset
Security
Load boot logo / animation
Press to load boot logo / animation from USB flash drive
Update server type
Specify the update server type
TFTP
Get Update Server from DHCP server
✓
Update server type
Default setting: TFTP
The following settings are possible:
TFTP TFTP
(Trivial File Transfer Protocol) is a very simple data transfer protocol.
FTP
1)
FTP (File Transfer Protocol) offers more possibilities than TFTP .
1) The update server type FTP is only available for devices with hardware revision C0 and later.
Get Update Server from DHCP server
Default setting: Enabled
All information required by the update server for the configured type is requested from the DHCP server. This
corresponds to the information that must be entered manually if the option is disabled (see the following two sections
"Configuring a TFTP or FTP update server").
If the option is disabled, one or more additional input fields are displayed depending on the selected update server
type. They are described in the following two sections:
5.1.11.1.1 Configuring an TFTP update server
If option Get Update Server from DHCP server is disabled and update server type TFTP is selected, then input
field Hostname / IP address is also displayed:
VNC
Web
Storage
Update
Backup & Reset
Security
OPC UA
Load boot logo / animation
Press to load boot logo / animation from USB flash drive
Update server type
Specify the update server type
TFTP
Get Update Server from DHCP server
Hostname / IP address
Hostname / IP address
Default setting: EMPTY (no update server entered)
To update a Power Panel from a TFTP server, a hostname or IP address for the TFTP server must be specified.
By default, port 69 is used for the connection to the TFTP server.
If the TFTP server makes its services available on a different port, the port must be specified explicitly together
with the IP address or hostname:
Syntax Example Description
IP address:Port 10.23.20.38:1069 A connection to IP address 10.23.20.38 is established on port 1069 .
Hostname:Port tftp server:1169 A connection to the host tftp-server is established on port 1169 .
Information:
If the specified IP address is incomplete or a TFTP server does not exist for the IP address or the
specified hostname, a message is output indicating that a network connection could not be established
when attempting to connect fails during the update procedure.