B&R MAPPC800-ENG, User Manual

Page: 160 / 396

160
Commissioning • Configuration of a SATA RAID array
Panel PC 800 User's Manual V 1.00
7.3 Rebuild mirrored set
The "Rebuild mirrored set" menu can be used to restart a rebuild procedure in a RAID 1 network
if an error occurs, after first interrupting the rebuild procedure or when exchanging a hard disk.
If "onlinerebuild" is selected, then the rebuild is executed during operation after the system is
booted. E.g. an event pop-up is displayed by the installed SATA RAID configuration program:
SATARaid detected a new event
and the rebuild is started. The entire rebuild lasts
approximately 50 minutes.
If "offlinerebuild" is selected, then a rebuild is performed immediately before starting the
operating system (lasts approximately 30 minutes).
Figure 78: RAID Configuration Utility - Rebuild mirrored set
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2006
Create RAID set
Delete RAID set
Rebuild help
Resolve Conflicts
Low Level Format
0 PM
1 SM
0 ST96023AS Select Menu
1 ESC Previous Menu
Enter Select
Ctrl-E Exit
* First HDD
ST96023AS 55GB
ST96023AS 55GB
* Set0 SiI Mirrored Set <PM> 55GB
Current
ST96023AS rebuild
Rebuild Mirrored set
onlinerebuild
offlinerebuild