B&R MAPPC700A-ENG, User Manual

Page: 268 / 524

268
Software • BIOS options
Panel PC 700 with 945GME N270 CPU board User's Manual V 1.16
1.4.8 IDE Configuration
Figure 154: X945 Advanced IDE Configuration
BIOS setting Meaning Setting options Effect
ATA/IDE
Configuration Option for configuring the integrated
PATA and SATA controller. Disabled Both controllers disabled.
Compatible Both controllers run in Legacy or Compatible
Mode.
Enhanced Both controllers run in Enhanced or Native Mode.
IDE Channel
Control
1)
Option for configuring the IDE channels in
"Compatible" mode. SATA only Only use SATA drives.
SATA Pri, PATA Sec SATA drives are address primarily and PATA
drive secondarily.
PATA only
2)
Only use PATA drives.
Primary IDE Master The drive in the system that is connected
to the IDE primary master port is
configured here. Enter Opens the submenu
See "Primary IDE Master", on page 270
Primary IDE slave The drive in the system that is connected
to the IDE primary slave port is configured
here. Enter Opens the submenu
See "Primary IDE slave", on page 272
Secondary IDE
Master The drive in the system that is connected
to the IDE secondary master port is
configured here. Enter Opens the submenu
Table 113: X945 Advanced IDE Configuration setting options
Advanced
IDE Configuration Options
ATA/IDE Configuration [Compatible] Disabled
IDE Channel Control [PATA only] Compatible
Enhanced
Primary IDE Master : [ ]
Primary IDE Slave : [ ]
Not Detected
Hard Disk
Hard Disk Write Protect [Disabled]
PATA Detect Time Out (Sec) [35] Select Screen
SATA Detect Time Out (Sec) [3] Select Item
ATA(PI) 80Pin Cable Detection [Host & Device] +- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
v02.66 (C)Copyright 1985-2009, American Megatrends, Inc.