B&R Automation PC 620, User Manual

Page: 301 / 594

Software • BIOS options
Section 4
Soft
w
are
301 Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
Legacy devices
Figure 139: X945 Legacy Devices
BIOS setting Meaning Setting options Effect
COM C Setting of the COM port for the touch
screen on the monitor/panel connector.
Disabled Disables the interface.
Enabled Enables the interface.
Base I/O address Selection of the base I/O address for the
COM port. 238, 2E8, 328, 338, 3E8 Selected base I/O address is assigned.
Interrupt Selection of the interrupt for the COM port. IRQ 5, IRQ 6, IRQ 7,
IRQ 10, IRQ 11
Selected interrupt is assigned.
COM D Setting of the COM port for the touch
screen on the AP Link connector.
Disabled Disables the interface.
Enabled Enables the interface.
Base I/O address Selection of the base I/O address for the
COM port. 238, 2E8, 328, 338, 3E8 Selected base I/O address is assigned.
Interrupt Selection of the interrupt for the COM port. IRQ 5, IRQ 6, IRQ 7,
IRQ 10, IRQ 11
Selected interrupt is assigned.
COM E Configuration of the COM port on the B&R
add-on interface 5AC600.485I-00 (IF
option). Disabled Disables the interface.
Enabled Enables the interface.
Base I/O address Selection of the base I/O address for the
COM port. 238, 2E8, 328, 338, 3E8 Selected base I/O address is assigned.
Table 189: X945 Legacy Devices setting options
Advanced
Legacy Devices Enable/Disable the
internal COM port
for touch
CAN: [Disabled]
COM D: [Disabled]
COM E: [Disabled] Fot detailed
descrpition see user
manual.
COM C: [ ] Disabled
ETH2 LAN controller: [Enabled]
Select Item
Select Screen
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
ETH2 MAC Address: 00:60:65:04:D0:F8
BIOS SETUP UTILIT Y
v02.66 (C)Copyright 1985-2009, American Megatrends, Inc.