B&R Automation PC 620, User Manual

Page: 220 / 594

220
Commissioning • Connection examples
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
4.3 An Automation Panel 900 via SDL (onboard)
An Automation Panel 900 is connected to the integrated SDL interface (onboard) via an SDL
cable. USB devices can only be connected directly to the Automation Panel (without a hub).
4.3.1 Basic system requirements
The following table shows the possible combinations for the APC620 system unit with CPU
board to implement the configuration shown in the figure above. If the maximum resolution is
limited when making the combination then it is also shown in this table (e.g. for connecting a non-
B&R Automation Panel 900 device).
4.3.2 Link modules
Figure 96: Configuration - An Automation Panel 900 via SDL (onboard)
CPU board with system unit Restriction
Resolution
5PC600.SX01
-00
5PC600.SX02
-00
5PC600.SX02
-01
5PC600.SF03
-00
5PC600.SX05
-00
5PC600.SX05
-01
5PC600.SE00
-00 / -02
5PC600.X945-00
✓
-
✓
- -
✓ ✓
Max. UXGA
Table 120: Possible combinations of system unit and CPU board
Model number Description Note
5DLSDL.1000-00 Automation Panel Link SDL receiver
Connection for SDL in, transfer of display data, touch screen, USB 1.1, matrix keys, and service data,
24 VDC (screw clamp 0TB103.9 or cage clamp 0TB103.91 sold separately).
For Automation
Panel 900
Table 121: Link module for the configuration - One Automation Panel 900 via SDL
Automation PC 620
SDL segment length
max. 40 meters
Link: 5DLSDL.1000-00
✓
USB OK
0
Graphics Engine 1
x Internal APC620 panel number
Monitor / Panel
connection
independent of segment length