B&R ACOPOSinverter P84, User Manual

Page: 219 / 405

Programming guidelines
ACOPOSinverter P84 User's Manual 2.10 219
2.8.11.10 Limit switch management
This function can be used to manage train control limits with limit switches.
The stop mode can be configured. If the stop contact is activated, the start in the other direction is authorized.
Example:
Stop
Movement in left direction
Stop
Movement in right direction
Movement in
left direction
Movement in
right direction
The stop is activated when the input is at 0 (open contact).
[LIMIT SWITCH MANAGEMENT] (LSt-)
Code Name/Description Factory settings
LSt- [LIMIT SWITCH MANAGEMENT]
Note:
This function cannot be used with certain other functions. Follow the instructions in see "APPLICATION FUNCT. FUn-" on page 197 .
LAF [Stop FW limit sw.] [No] (nO)
nO [No] (nO) : Function not active
LI1 [LI1] (LI1) to [LI6] (LI6)
C101 [C101] (C101) to [C115] (C115) : Not applicable
- [C201] (C201) to [C215] (C215) : With built-in communication interface in [I/O profile] (IO)
-
[C301]
(C301) to
[C315]
(C315) : With communication card in
[I/O profile]
(IO)
Cd00 [CD00] (Cd00) to [CD13] (Cd13) : In [I/O profile] (IO) the switchover is possible with logic inputs
- [CD14] (Cd14) to [CD15] (Cd15) : In [I/O profile] (IO) the switchover is possible with logic inputs
LAr [RWStop.] [No] (nO)
The same assignments are possible as for [Pos forw. stop] (LAF) (see below).
LAS
[STOP CONFIGURATION] [freewheel stop]
(nSt)
rMP [Ramp stop] (rMP)
FSt [Fast stop] (FSt)
nSt [freewheel stop] (nSt)
If the assigned input becomes 0, the stop is controlled according to the selected type. After the motor stops, a restart is only authorized for the
other direction.
If the two inputs [Pos forw. stop] (LAF) and [RWStop.] (LAr) are assigned and in state 0, a restart is impossible.
This parameter can be accessed if [Pos forw. stop] (LAF) or [RWStop.] (LAr) is assigned.