Technical data • Complete system
34
Panel PC 2100 swing arm user's manual V1.00
2.4.9 LED status indicators
LED status indicators are located on the bottom of the PPC2100 between the ETH2 interface and the power button.
Power LED
CFast LED
Link LED
Run LED
The following timing is used for the LED status indicators:
Block size: 250 ms
Repeat interval: 500 ms, 2 boxes thus represent one interval
LED
Color
Status
Function
LED status indicators
Green
On
Voltage supply OK
Red
On
System in standby mode (S5: Soft-off mode or S4: Hibernation
mode suspend-to-disk)
Faulty or incomplete BIOS, MTCX or I/O FPGA update, voltage
supply OK
Power
Red/Green Blinking
Faulty or incomplete BIOS, MTCX or I/O FPGA update, stand-
by mode (S5: Soft-off mode or S4: Hibernation mode sus-
pend-to-disk)
CFast
Yellow
On
Indicates CFast access
On
Indicates an active SDL connection on the male panel connec-
tor
Indicates that an active SDL connection has been interrupted
by a loss of power to the display unit
Link
Yellow
Blinking
Information:
Check the voltage supply / power connector of the
connected display unit.
Green
Blinking
Automation Runtime booting
Controlled by Automation Runtime (ARemb and ARwin)
Green
On
Application running
Controlled by Automation Runtime (ARemb and ARwin)
On
Application in service mode
Controlled by Automation Runtime (ARemb and ARwin)
Run
Red
Blinking
Indicates a licensing violation
Table 30: LED status indicators - Data
2.4.10 IF option slot (IF1, IFx)
Panel PC system units include 1 slot for an interface option.
The following table lists the interface options that can be used in this IF option slot.
IF option IF1, IFx slot
Model number
Short description
Interface option
5ACCIF01.FPLS-000
Interface card - POWERLINK - RS232 - 32 kB FRAM
5ACCIF01.FPSC-000
Interface card - POWERLINK - CAN - RS232 (Rx/Tx) - 32
kB FRAM
IF1 IF option
IFx IF option
Table 31: IF1 IF option, IFx slot
Information:
Interface options can only be installed and replaced by B&R.
