Installation • Installation
Chapter 3 Installation
Panel PC 2100 swing arm user's manual V1.00
89
9. Pull firmly and evenly on the mounting bracket to remove the system unit.
Mounting bracket
Figure 46: Removing the system unit
10.The system unit can now be replaced by following these steps in reverse order. The maximum tightening
torque of the Torx screws (T10) is 0.5 Nm.
Only the mounting materials included in delivery are permitted to be used to install the system unit.
11.Replace the interface cover on the Panel PC using the 9 to 12 Torx screws (T10) removed earlier (0.6 Nm
tightening torque).
The interface cover must be installed correctly to ensure IP65 protection.