B&M 80212 Installation Instructions Download Page 3

Page: 3 / 3

Temperature Sender

Note: Sender Body / Connecting

T-fitting must be connected to

Chassis Ground

GND Stud - To Chassis Ground

( )

Negative ("-") Stud - To

Temperature Sender

Spade Terminal - To

Instrument Illumination

Circuit

Positive ("+") Stud - To

Ignition Terminal (Switched

12V circuit)

Temp Gauge

Figure 3: Electrical Details

Summary of Contents for 80212

Page 1: ...latest technical product information Part Number 80212 80226 2005 by B M Racing and Performance Products Rotate gauge until it is properly aligned and tighten each nut finger tight STEP 2 Locate the...

Page 2: ...nut Tighten nut snugly DO NOT OVER TIGHTEN AS THIS COULD DISTORT BRACKET OR DAMAGE GAUGE Connect other end of wire to an accessory or ignition circuit that is hot when the ignition key is on DO NOT AL...

Page 3: ...tting must be connected to Chassis Ground GND Stud To Chassis Ground Negative Stud To Temperature Sender Spade Terminal To Instrument Illumination Circuit Positive Stud To Ignition Terminal Switched 1...