20
Source Names Setup
From the factory, your Preamplifier Tuner will display source names that match those printed on the rear of the
Preamplifier Tuner and on the supplied remote. However, this menu allows you to change the displayed names to
match the actual sources used. If you do not want to change the names then skip this step. Note that the tuner
name cannot be changed.
From Remote
From Front Panel
Action
1
From setup menu:
À
or
§
From setup menu:
.
(TUNE +) or
-
(TUNE -)
move to source names
2
SEL or ENTER
↵
(ENTER)
enter source names menu
3
Desired source
(SOURCE) step to source
select desired source for renaming
4
À
or
§
.
(TUNE +) or
-
(TUNE -)
change blinking character
5
¶
(BAL L) or
•
(BAL R)
VOLUME KNOB
move to new character position
6
repeat 4-5
repeat 4-5
until all renaming complete
7
Repeat 3-6
repeat 3-6
to rename additional sources
8
MENU
◊
(PRESET) and
↵
(ENTER)
return to setup menu
Source Levels Setup
This setup allows you to match the levels of your sources so that there are no large changes in volume as you
change from one source to another. This is for your convenience only and need not be performed unless you wish
to. You may use a SPL meter or your ear to adjust the levels. Note that the levels will depend not only on this
setting but also on the source material being played back. You may wish to use a test disc. Note that the only
setting permitted are 0 and -6dB
.
From Remote
From Front Panel
Action
1
From setup menu:
À
or
§
From setup menu:
.
(TUNE +) or
-
(TUNE -)
move to source levels
2
SEL or ENTER
↵
(ENTER)
enter source levels menu
3
Desired source
(SOURCE) step to source
select desired source for level setup
4
¶
(BAL L) or
•
(BAL R)
VOLUME KNOB
set desired level
5
repeat 3-4
repeat 3-4
set additional source levels
6
MENU
◊
(PRESET) and
↵
(ENTER)
return to setup menu
SOURCE LEVELS
V1 VCR -6db
SOURCE NAMES
V1 VCR
