13
S
B
I M P LY
E T T E R !
B K
&
Press buttons slowly. The MZ-128 will not respond to rapid button presses while in setup.
Code-set 128
Code-set 128 is a special IR code-set which allows control only from a Hardware Zone Input
Port. Code-set 128 will not control an HD6 via any IR receiver.
Code-set 999 [B & K ALL Commands]
[ON] [B&K]
B & K POWER ON
OFF
B & K POWER OFF
IR REMOTE CONTROL
The MZ-128 Remote Controller has multiple functions:
1) The MZ-128 Remote Controller may be used to control and setup B&K products.
2) The MZ-128 may be used as a source of IR for use in programming learning keypads etc...
3) The MZ-128 may be used to directly control a single zone of an HD6 with an external IR
eye or keypad connected.
Note: No remote or keypad will function directly with the HD6 while it is LINKED to a CT Receiver.
Send IR / Keypad messages directly to the CT Receiver.
MZ-128 CT Series IR Remote Controller
Setup the MZ-128 to use a discrete B & K code-set:
1) Install 4 AAA batteries into the remote. Observe polarity.
2) Press and hold the B & K and MUTE buttons simultaneously for two seconds. The LED will
light up solid red and stay illuminated.
3) Enter the desired B & K three digit code-set. Always use three digits (i.e. 0 1 1)
4) Press the B & K button again to confirm setup. The red LED should blink three times when
the IR code has been successfully programmed.
MZ-128 Button
HD6 Function
MZ-128 Button
HD6 Function
B&K
POWER ON
SAVE
SAVE
POWER
POWER TOGGLE
MENU
MENU
MUTE
No Function
LEFT
LEFT
OFF
POWER OFF
RIGHT
RIGHT
VOLUME UP
No Function
SEL / ENTER
SELECT / ENTER
VOLUME DN
No Function
UP
UP
PRESET UP
No Function
DOWN
DOWN
PRESET DN
No Function
EXIT
EXIT
IN 1
IN 1
ZONE
ZONE SELECT
IN 2
IN 2
1
1
IN 3
IN 3
2
2
IN 4
IN 4
3
3
IN 5
IN 5
4
4
IN 6
IN 6
5
5
IN 7
IN 7
6
6
IN 8
IN 8
7
7
IN 9
IN 9
8
8
D-IN
DEDICATED ZONE INPUT
9
9
AM
No Function
+10
+10
FM
No Function
0
0
M
No Function
ENTER
SELECT / ENTER
V+
VIDEO SOURCE UP
LOUD
No Function
T+
No Function
T-
No Function
B+
No Function
TUNE -
No Function
B-
No Function
TUNE +
No Function
S+
SOURCE UP
STA -
No Function
S-
SOURCE DOWN
STA +
No Function
