DIP
Led
Function
Signal
Description
Description
Status
Colour
ON
Green
Green
Green
Red
Green
Red
Yellow
ON
OFF
OFF
DIP1
DL1
DL2
DL3
DL6
DL4
DL7
DL5
DIP1
DIP2
ON
ON
DIP 2
PHOTOCELL
GENERAL OPEN
GENERAL CLOSE
START
PHOTOCELL
MEMO
RADIO
SAFETY
STOP NC
Disables PHOTO input
Disables SAF input set as STOP with NC contact
It switches on when the contact is closed
It switches on when the contact is closed
It switches on when the contact is closed
It switches off when the photocell contact opens
See “Times learning procedure”
See “On board radio management”
The led switches on with the SAF input enabled. It remains on for 2 s, then it
switches off and, after a few seconds, on again.
PHOTO input enabled
Enables SAF input set as STOP with NC contact.
Enables 8K2 edge reading
DEFAULT SETTINGS
SIGNALLING LEDS
ON BOARD RADIO MANAGEMENT
FUNCTIONS SETTING ( DIP SWITCH DIP2)
Settings are memorized when the door is closed.
SPECIFICATIONS
Radio receiver 433,92 MHz
Memorizable codes max 200
CODES LEARNING
Press the LEARN key, the DL8 led switches on (it remains on for 6 s, then it switches off).
Press the key selected with the dip n° 6 – 7 of the transmitter that has to be set, and the receiver gives a start
command to the control unit. Without pressing again the LEARN key, it is possible to memorize other transmitters of
the same kind one after the other until the DL8 led remains on. After the learning of the last transmitter, wait until the
led switches off (about 6 s) to indicate that the system has left the learning procedure and is now ready for the
standard work.
Without pressing the LEARN key, it is possible to memorize the transmitters just by pressing simultaneously the keys
1 and 2 of a transmitter already memorized on the control unit for about 6 s. In this way, the transmitter enters the code
learning mode; it is now necessary only to press any of the keys of the new transmitter that has to be memorized.
MEMORY DELETION
In case of mistake, or when the complete deletion of all codes is necessary, press the LEARN key (the red led
switches on) and keep it pressed until the led switches off.
SR100
13
UK
