Attach the wind sensor
Mounting template
Bracket installation
1
Remove the wind sensor
1
2
1a
1b
2b
2a
Bluetooth base station mounting
Prior to pairing
1.
Connect the Bluetooth base station to the NMEA 2000 network
2.
Have the battery for the wireless wind sensor on-hand for later installation
3.
The wind sensor must be less than or equal to 0.5 meters (1.6 ft) from the Bluetooth base station for pairing to succeed
Ready to pair
4.
Power on the NMEA 2000 network
5.
Insert and connect the battery to the wind sensor
6.
The Bluetooth base station and wind sensor will now attempt to pair. This can take up to 5 minutes to complete
Successful pairing
7.
On an MFD or instrument display, go to the Device List in the Network settings dialog
8.
Select the WS320 device to display the device information dialog
9.
Select the Data option to display information
10.
Check that the apparent wind angle and speed are correctly updating
The wind sensor is now ready to be installed at the top of the mast. Wind angle calibration can be done later from the calibration
option in the network settings dialog.
¼
Note:
If the battery is disconnected, the sensor will lose its pairing with the base station and the above procedure must be
repeated.
Pairing
Insert the battery
¼
Note:
Pairing should be carried out prior to installing the wind sensor on the mast.
Warning:
Risk of explosion if the
battery is replaced by incorrect
type!
20 mm
(0.79”)
FOR
W
ARD
LC
36 mm
(1.42”)
19 mm
(0.75”)
10 mm
(0.39”)
PRODUCT
OUTLINE
40.5 mm
(1.60”)
46.8 mm
(1.84”)
Material
10# screw
Hard materials e.g. fiberglass, aluminum, carbon fibre
Ø 4.1-4.7 mm (3/16”)
Recommended pilot holes:
Surface mount
Pole mount
1
2
3
4
1
2
3
Refer to
Mounting template
988-10452-00n
2
1
3
