B&G Vulcan R, Installation Manual

Page: 16 / 72

Installation
Mounting location
Choose the mounting locations carefully before you drill or cut.
For overall width and height requirements, refer to
"Dimensional
drawings"
on page 68.
Do not mount any part where it can be used as a hand hold, where
it might be submerged, or where it will interfere with the operation,
launching, or retrieving of the boat.
The unit should be mounted so that the operator can easily use the
controls and clearly see the screen.
The unit has a high-contrast screen and is viewable in direct
sunlight, but for best results install the unit out of direct sunlight.
The chosen location should have minimal glare from windows or
bright objects.
The mounting location and surrounding materials may affect the
internal wireless and/or GPS performance. Metal and carbon
materials are known to impact the performance in a negative way.
Test the unit in its intended location to ensure satisfactory
reception.
An external GPS source can be added to overcome poor GPS
reception areas.
An external wireless module can be added to compatible devices to
overcome poor wireless reception areas.
Consider access to the card reader which is located in the back of
the unit.
Check that it is possible to route cables to the intended mounting
location.
Leave sufficient clearance to connect all relevant cables.
Before cutting a hole in a panel, make sure that there are no hidden
electrical wires or other parts behind the panel.
Ensure that any holes cut are in a safe position and will not weaken
the boat’s structure. If in doubt, consult a qualified boat builder, or
marine electronics installer.
Ú
Note:
Where flush mounted, the enclosure should be dry and
well ventilated. In small enclosures, it may be required to fit
forced cooling.
3
16
Installation | Vulcan R Series Installation Manual