4.
Click on “Configure” button at the bottom left of the dropdown box.
5.
In “Analogue type” dropdown box select appropriate type, e.g. “Forestay”
6.
Fill in table; Analog value 1 - 0.00
Analog value 2 - “Cal Equivalent Load” (e.g 2.88 Tonnes)
Analog Voltage 1 - Recorded “zero” voltage from step 2.
Analog Voltage 2 - Recorded “Cal” voltage from step 3.
7.
Click on “Apply Values”
8.
With Cal switch still on confirm that H5000 displays now read a “Forestay” value of the Cal
equivalent load (in this example 2.88T)
9.
Turn off Cal switch. System is now set up
N.B. If the web page is accessible when tuning the HLA analogue output, steps 1. and 2. can be used
to adjust zero and span pots on the HLA as these values are simply reading voltage “V Out” from the
HLA .
