PAW-150
V2.0
2
PAW-150
V2.0
2
COMPONENTS AND RECOMMENDED LOCATIONS IN THE VEHICLE
(1) Electronic unit
(1) Hand microphone
(1) 100W loudspeaker
(1) Hand microphone harness
(1) Power cable
(1) Fuse 15A
(1) Fuse 25A
(1) Loudspeaker harness
HAND MICROPHONE
ELECTRONIC UNIT
PAW-100
100W
LOUDSPEAKER
INSTALLATION AND ELECTRIC DIAGRAM
To install the equipment, see the wiring diagram shown further on.
Avoid leaving visible cables in the cabin to leave the vehicle’s aesthetics unaffected.
If there are any cables left disconnected, insulate them with tape; disconnected cables
making an undesired contact can cause a malfunction.
Electronic Unit
Place it on a hidden location for aesthetic purposes. Make sure that the
location allows some ventilation into the unit to avoid overheating.
HIGH
SIREN
BASS
HORN
H / S
AUX
Mp3
VOL
WAIL
HI-LO
FLASH
YELP
PHSR
PIER
NGI
LAMP
LAMP
A
C
B
CONNECTOR A CONNECTOR B
1
2
3 5 7 9
4 6 8 10
1
2
3 5 7
4 6 8
PAW-150
HAND MIC.
Hand Microphone
To facilitate the handling of the equipment, place the microphone on a
location within the driver’s reach, such as the console of the vehicle.
To clean the microphone keyboard, gently wipe it with a dry cloth. Do not
use water or any solvent.
Loudspeaker
When selecting the location for the loudspeaker, keep in mind that this
component is weather resistant but it is not immersion-proof. The
loudspeaker must be placed as far as possible from the keyboard (where
the internal microphone is) to prevent feedback.
Splice and tape the loudspeaker wires to the output wires (they have no
polarity).
OPERATING PROCEDURES
All of the equipment’s functions are managed through the hand microphone (see fi gure in
the next page). Press the buttons with your fi ngertips, do not use objects to press them.
