2
3
MPA-30A
MPA-30A
2
MPA-30
COMPONENTS AND INSTALLATION
Switchbox (1)
Attach it to the left handle
bar using the mirror
screws to fasten it.
Make sure to place it
within the driver’s reach.
MPA-30
Louds Electronic
Module (1)
Install it onto the slide bars
using either clamps
and/or screws (not
included), or welding it.
SIREN
LIGHTS
M.WAIL
HORN
Front lights (2)
(optional)
Fasten the lights to the bumper.
Rear light (1)
(optional)
Fasten to the trunk.
CONNECTION DIAGRAM
White
+12V
GND
LIGHTS (optional)
Yellow*
(wire to select
the flash pattern)
4P
4P
4P
4P
4P
4P
MTL-FBT
MTL-FBT
MTL-R
6P
SWITCHBOX
LOUDS
ELECTRONIC MODULE
BATTERY
+12V
+
-
6P
SIREN
LIGHTS
M.WAIL
HORN
Black
Red
FUSE
10A
* The optional lights include 10 flash patterns. To select one, take the yellow wire coming from the harness and
connect it momentarily to the power source (12V); the pattern will switch every time the cable makes contact with
the source. Once the flash pattern has been selected, make sure to isolate the yellow wire.
OPERATION OF SIREN SOUNDS
Reproduction of the M.WAIL sound
1. To turn on, press and hold M.WAIL.
2. To turn off release the switch; M.WAIL will stay on for as
long as the switch is pressed.
3
MPA-30
Reproduction of the HORN sound
1. To turn on, press and hold HORN.
2. To turn off release the switch; HORN will stay on for as long
as the switch is pressed.
NOTE:
The activation of HORN overrides other functions. Once HORN is released, the
equipment returns to the function which was executing when HORN went on.
Reproduction of the SIREN sound
1. To turn on, pull up SIREN.
2. To turn off, pull down the switch to its central position.
NOTE:
If there are lights connected to the system, when SIREN is activated the lights will
go on automatically.
CHANGING BETWEEN MODES FOR SIREN TONE SELECTION
The equipment offers two modes for changing the SIREN tone (modes are explained
further ahead). To select the mode of your preference, follow the steps below.
1. Press and hold M.WAIL.
2. While M.WAIL is held down, pull up SIREN.
• If it beeps once: The equipment is in Mode 1.
• If it beeps twice: The equipment is in Mode 2.
3. Press and release M.WAIL to switch between
modes.
4. Once the preferred mode is selected, pull down SIREN to
its central position.
MODE 1: Setting up the SIREN tone
1. Press and hold HORN.
2. While HORN is held down, pull up SIREN. HORN will stop,
indicating that you have entered confi guration mode.
3. Release HORN, the current SIREN tone will start.
4. Press and release HORN to switch among the available
SIREN tones (PHASER, WAIL, Hi-Lo & YELP). Once the tone
is selected, pull down SIREN to its central position.