![background image](http://html1.mh-extra.com/html/bandelin/sonorex-technik-mb/sonorex-technik-mb_operating-manual_3827586013.webp)
23626-002 GB/2021-10
13 / 24
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
2.2
Setup / assembly
Fully remove transportation aids (pallets, transport safety devices).
The lifting device is delivered with the support arms in the lower position.
Set up the device in a dry room and level the device using
the height-adjustable feet.
Check the switch positions on the lifting device:
EMERGENCY STOP pulled.
Connect the lifting device to three-phase current 400 V 3N~ (± 10%) 50 Hz.
Turn on the main switch.
The touchscreen operation is initialised.
If the message “Phase fault” is displayed, a check must be performed by
authorised specialist personnel:
1) Are the phase voltages correctly connected to the socket?
If
yes,
2) two phases must be replaced in
the three-phase plug of the lifting device.
To do this, use a slotted screwdriver to
turn the centre pins in the plug by 180°.
Place the tank(s) onto/into the tank rack
positions
fi
xed with screws; insert drip plates
between the tanks if required.
2.3
Putting into service
Movable lifting devices must be moved manually between the SONOREX TECHNIK RM/
TM baths (cleaning or rinsing baths). They must snap into the stand, centred above
the respective bath.
Position the lifting device centrally above the SONOREX TECHNIK RM/TM bath.
Hang the basket onto the support arms of the lifting carriage.
Summary of Contents for SONOREX TECHNIK MB
Page 24: ......