Coding the Wireless Keypad into the Opener
a.
Press the CODE SET button and release. The CODE SET LED will illuminate to
indicate that the opener is in Code Learn mode. If a valid code is not stored
within 15 seconds, the opener will exit Code Learn.
b.
Enter your pin code on the Wireless Keypad followed by the hash (#) key.
Then press one of the eight (channel) buttons you wish to use to operate the
door or gate etc. CODE SET LED will flash.
c.
Pause for a second and press the same button again on the Wireless Keypad.
The CODE SET LED will illuminate for one second then go out.
d.
Test the operation of the Wireless Keypad by entering your pin code
followed by the hash (#) key and the stored channel button (1-8). The door
should start to move.
Coding the Wireless Keypad into the Tri-Tran
™
receiver
a.
Press and hold SW1/SW2 on the Tri-Tran
™
receiver board.
b.
Enter your pin code on the Wireless Keypad followed by the hash (#) key.
The press one of the eight (channel) buttons you wish to use to operate the
door or gate etc. CODE SET LED will flash.
c.
Pause for a second and press the same button again on the Wireless Keypad.
d.
Release the SW button. The Wireless Keypad code should now be stored into
the receiver
’
s memory.
e.
Test the operation of the Wireless Keypad by entering your pin code
followed by the hash (#) key and the stored channel button (1-8).
