Controll-A-Door
®
Power Drive & Roll-A-Pro
®
Instruction Manual
12
14. Coding a Transmitter
Storing the Transmitter Code
The opener can only operated from remote control transmitters that have
been programmed into its memory. Up to 64 codes can be stored in the
memory.
a. Press the CODE SET button and release. The CODE SET LED will illuminate
to indicate the opener is in Code Learn mode. If a valid code is not
stored within 15 seconds the opener will exit Code Learn.
b. Press the transmitter button one (1) to control the door. The
CODE SET LED will flash.
c. Press the same transmitter button again. The CODE SET LED will illuminate
for one second then go out.
d. The transmitter button is now coded - press to test.
Coding a Transmitter to the Courtesy Light
The transmitter can be programmed to operate the courtesy light on the
opener independently of the door moving.
a. Press the CODE SET button twice - the CODE SET LED and courtesy light
will both illuminate.
b. Press one of the four buttons on the transmitter for two (2) seconds,
pause for two (2) seconds, then press the same button again for two (2)
seconds.The CODE SET LED will illuminate for one second then go out.
c. Press the transmitter button to test.
Coding a Transmitter Button to Enable Vacation Mode
The opener can be programmed into a “Vacation Mode” where the opener
will not respond to any transmitter except the button of the transmitter that
was programmed for vacation mode.
a. Press the CODE SET button three (3) times - the CODE SET LED will illuminate
and the courtesy light will flash slowly.
b. Press one of the four (4) buttons on the transmitter for two (2) seconds,
the CODE SET LED will begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c. The CODE SET LED will illuminate for one second and then go out, and
the courtesy light will also switch off. This indicates the code has been
stored.
d. Press and hold the transmitter button for five (5) seconds to set Vacation
Mode. The CODE SET LED will stay lit while Vacation Mode is active.
e. To reset Vacation Mode, press the same button for two seconds, until the
CODE SET LED turns off.
Coding a Transmitter to enable AUX Output
a. Press the CODE SET button four (4) times - the CODE SET LED will illuminate
and the courtesy light will flash quickly.
b. Press one of the four (4) buttons on the transmitter for two (2) seconds,
the CODE SET LED will begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds. The CODE SET LED will
illuminate for one second then go out.
c. Press the transmitter button to test.
Button 1
TB-6 Shown
IMPORTANT NOTE: Only Tri-Tran+
TM
Technology Transmitters are compatible
with these RDO-1 products.
