Wiring and Installation Instructions
Safety Beam Kits
EASYBEAM P.E. 3-V1 KIT
ATA ORDER NO. 61904, B&D ORDER NO. 62626
ITEM DESCRIPTION
QTY
14
EASYBEAM RX-TX SET
1
4
MOUNTING KIT
1
PE 2000TS KIT -
ATA ORDER NO. 61903, B&D ORDER NO. 62852
ITEM DESCRIPTION
QTY
15
PE BEAM IR-2000TS
1
4
MOUNTING KIT
1
ACCESSORY KIT -
16
RESISTOR 2K2 PACK
1
17
RESISTOR 5K6 PACK
1
INTERFACE KIT V2 (ACB / DCB BOARDS ONLY) -
18
HARNESS P.E. RX 24AWG 10M
1
19
HARNESS P.E. RX-TX 17M
1
EasyBeam
TM
PE-3v1
PE 2000TS
WPE-1V1 KIT -
ATA ORDER NO. 61957, B&D ORDER NO. 70300
ITEM DESCRIPTION
QTY
1
WPB-04.02 TX ASSEMBLY
1
2
WPB-04.02 RX ASSEMBLY
1
3
WPB-04.03 BASE STATION ASSEMBLY
1
4
MOUNTING KIT
1
FLUSH MOUNTING KIT -
5
PEB4-W1 BRACKET
2
6
TAPTITE SCREW “P” M3 X 8
8
7
SELF TAPPING SCREW M6 X 25
4
8
PLASTIC WALL PLUG 6.7 X 25
4
PEB4-W1 HARDWARE KIT 2 -
9
PLASTIC WALL PLUG 6.9 X 25
2
10
SELF TAPPING SCREW M6 X 25
2
11
TAPTITE SCREW “P” BLACK ZNC M3 X 12
8
12
HEX SERRATION FLANGE NUT M6
1
13
HEX SERRATION HEAD SCREW M6 X 16
1
Wireless WPE-1v1
Important Safety Instructions
WARNING!
•
When using Safety beams, the doorway / gateway must be clear of all obstructions and
persons a all times. The location of the beams and manner in which they are installed
might not give safety protection at all times.
•
The sensors need to be 100mm above the floor level, however, the exact position must
be chosen in such a manner that it suits the application, the environmental conditions
and provides maximum safety protection.
•
When using auto close mode, a Safety beam must be fitted correctly and tested for
operation at regular intervals. Extreme caution is recommended when using auto close
mode. All safety rules must be followed.
ELECTROCUTION!
•
Disconnect the power cord from mains power and battery backup (if installed) before
making any repairs or removing covers on openers.
CAUTION:
Fall from ladder
•
Ensure ladder is the correct type for job.
•
Ensure ladder is on flat ground.
•
Ensure user has 3 points of contact while on ladder.
Entrapment
•
Ensure the garage door / gate is in good working order by undertaking regular servicing.
•
Safety beams must be installed if the closing force at the bottom edge of the door / gate
exceeds 400N (40kg)
Doc # 160044_07
Part # 13409
Released 14/12/17
