a. Disconnect the power supply to the opener.
b. For SDO-6, SDO-7 and SDO-9:
i. Remove the left hand side pocket from the opener.
ii. Reach inside the opener and pull out the 4 pin
harness and connect to the wireless basestation
module.
For SDO-8:
iii. Remove back cover to expose control board.
iv. Reach inside the opener and pull out the 4 pin
harness and connect to the wireless basestation
module.
c. Place the module into the pocket and refit the cover.
d. Reconnect power to the opener and test operation.
e. Upon completion of a full cycle the lock will engage
into the track.
SDO-8
SDO-6, 7 & 9
connect basestation to opener
If a PE Beam is installed ensure that the channels on the basestation on each device are different.
The channel on the basestation can be changed by sliding the switch in either direction
.
tip
emergency operation
Press the emergency lock/unlock button on the front of the Auto-Lock
to disengage the locking bolt from the guide track and allow you to
disengage the opener and open the door.
WARNING! The emergency lock/unlock button on
this product is not to be used as a primary means of
locking the door under normal circumstances.
The emergency lock/unlock button is to be used only in case of power
outage or emergency.
battery change
a. Replace lock batteries (2 x C-LR 14) immediately when the Auto-lock
LED’s red and green lights flash 3 times or are flashing slowly.
b. Remove cover by unscrewing the four screws on the main cover.
c. Replace batteries, refit cover and secure with screws.
d. Operate opener to complete a full open / close cycle and ensure
Auto-lock engages.
Remove screws to
open main cover
4
Auto-Lock Kit -
Installation instructions
