B&B Electronics Conel ER75i Start Manual Download Page 3

Page: 3 / 4

START GUIDE ER75i

ER75s

Power cable connection

The router requires DC power supply from +10 to +30 V DC. The router has a built-in

protection against reverse polarity without signaling.

Connect power cable to PWR connector on the front panel of the (see figure below).

Ethernet cable connection

Ethernet cable is connected to ETH connector (see figure below). Ethernet cable is

used for configuration and communication with router.

If expansion port is assembled, cable is connected to port PORT1. Wiring of pins for

expansion port is described in manual of corresponding expansion port. These manual can
be found on the Conel website:

. Please, use the following

Username:

ConelFreeDownload

Password:

coneldownload

Power
connector

Ethernet
connector

Connector for
expansion port

Summary of Contents for Conel ER75i

Page 1: ...trictions concerning using radio based devices for example at petrol stations in chemical plants while working with explosives etc Switch off the router while travelling by plane Router operation aboa...

Page 2: ...connection Use FME connector for antenna connection Main antenna is connected by screwing at ANT connector see figure below Inserting SIM card The SIM card reader for 3 V and 1 8 V SIM cards is locat...

Page 3: ...is connected to ETH connector see figure below Ethernet cable is used for configuration and communication with router If expansion port is assembled cable is connected to port PORT1 Wiring of pins fo...

Page 4: ...et and web interface can be found in user manual on the Conel website http www conel com download Please use the fol lowing login information Username ConelFreeDownload Password coneldownload Restorin...