16
User Manual
IT8000
3/8” Tie
-Lok® Data Tool
Document #P80080 Rev. B
© Copyright
BAND-IT-IDEX, Inc. 2022
All rights reserved
All rights reserved
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Figure 15
Figure 16
Figure 14 - HMI
Figure 13
CONNECTING THE HMI AND REGULATOR TO CONTROLLER
The connection to the HMI (Human-Machine Interface) (Fig 14) is hardwired, so the green HMI cable only needs
to be connected to the controller. To connect the HMI cable to the controller, align the red dots and press the
connector in (fig. 13) On the side of the HMI is a USB port that can be used to transfer tool data. The system
regulator has two connections that must be connected (Fig.17). Each electrical connector has a unique interface,
do not attempt to force a plug into a connector if the receptable does not match or the key is misaligned.
The controller
has inputs for a Pass/Fail “cutoff signal” and
remote actuation to operate the tool hands free.
These do not need to be connected to run the tool in normal operation.
The controller has multiple switches. The I/0 power switch above the plug and the door latch function the same,
cutting all power and air to the controller. The E-stop on the top of the box removes air from the tool and power
to the motor. The HMI will remain on.
Figure 17
HMI Cable
Connector
E-Stop
Door Latch
Power Switch
Ethernet Port
Cable
Connections
Bank
Pneumatics
Valve Bank
Cut-off Signal &
Remote Trigger
Data Cable
HMI Key
Regulator
Connections
