Band-it G40269 Giant II Operating Instructions Download Page 2

Page: 2 / 3

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # P36187 Rev. G

BAND-IT-IDEX, Inc. 2007

www.BAND-IT-IDEX.com

Page 2 of 3

G40269 Giant II

Hand Tool

Cleaning and
Warranty

Gripper Cleaning Instructions:

1. Remove gripper. Align gripper pin
hole with notch in tool frame. Using a
punch and hammer, punch pin out of
slide block.

2. Using a wire brush, clean all
foreign matter from teeth.

3. Replace pin: Align gripper hole with
slide block hole, insert pin in hole and
hammer pin in place.

Refer to website for warranty information:

http://www.band-it-idex.com/warranty.html

NOTE

: Periodically apply food-grade white lubricant or equivalent to tension screw thread (on

page 3) to prevent excessive wear.

If tool fails to securely grip tail of clamp, follow gripper cleaning instructions above.

Summary of Contents for G40269 Giant II

Page 1: ...ar as possible to avoid buckle sliding into tool nose Apply tension by turning handle of tool 4 Place finger on BAND IT Band at buckle bridge while tensioning with tool handle When you feel BAND IT Ba...

Page 2: ...pin hole with notch in tool frame Using a punch and hammer punch pin out of slide block 2 Using a wire brush clean all foreign matter from teeth 3 Replace pin Align gripper hole with slide block hole...

Page 3: ...ricant or equiv to tension screw thread 3 When connecting the set screw to the cutter bar clean threads male and female of foreign matter then apply one drop of medium strength locking compound Loctit...