BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-627-3925
Document # P45087 rev. E
© Copyright
BAND-IT-IDEX, Inc. 2002
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 3
C002 JR
Hand Tool
Repair Parts &
Assembly
NOTES:
1. TO ASSIST IN REMOVING THREADED PARTS, APPLY HEAT
(SOFTENS LOCKING COMPOUND.
2. WHEN CONNECTING ITEM 6 (TENSION SCREW) TO ITEM 3
(SLIDE BLOCK), OR ITEM 22 (BUTTON HEAD SCREWS) TO ITEM 14
(JR. ADAPTER BODY) CLEAN THREADS (MALE AND FEMALE)
OF FOREIGN MATTER, THEN APPLY TWO DROPS OF HIGH
STRENGTH LOCKING COMPOUND (LOCTITE 271 OR EQUIV.)
ONTO MALE THREADS AND CONNECT PARTS TOGETHER.
3. BEFORE USING BAND-IT JUNIOR TOOL CHECK TO SEE THAT
THE CUTTER BLADE ITEM 17 AND BACKING PLATE ITEM 18 ARE
FULLY TIGHTENED. LOOSE SCREWS CAN CAUSE BREAKAGE
OFR CUTTER BLADE OR BACKING PLATE. USE (ITEM 19) HEX
KEY PROVIDED WITH TOOL TO TIGHTEN SCREWS IF NEEDED.
4. ASSEMBLE ITEM 11 (TENSION HANDLE) THEN ATTACH ITEM 10
(RETAINING RING, TEN. SCREW) TO ITEM 6 TENSION SCREW IN
LOCATION SHOWN. PLACE RING ON GROOVE, THEN PUSH RING
AGAINST A HARD SURFACE SUCH AS A TABLE UNTIL IT SNAPS
SECURELY IN PLACE.
