BALZER ELIMINATOR VACUUM TANK Series, User Manual

Page: 37 / 58

33 Eliminator Vacuum Tank (Tandem) User Manual
Suspension Height Adjustment
1 . Position the tractor and machine on level ground .
2 . Connect the two (2) yellow marked hoses to the tractor .
3 . Completely lower the machine by disengaging the straight steer function and opening all ball valves . Once the machine
is completely lowered, close all ball valves .
4 . Engage the straight steer function .
5 . Open the Left Side Base End ball valve and the Rod End ball valve slowly and simultaneously (Figures 41 and 42) . The
cylinders can be filled by opening the valves a little . This will provide more control while filling the cylinders .
6 . Raise the machine until the measurement of both exposed rods of the left cylinders equals 14” (35 .6 cm) . This will leave
the necessary average of 7” (17 .8 cm) of exposed rod (Figure 43) .
7 . Close both valves .
8 . Repeat for the right side cylinders .
The machine now has the suspension properly adjusted for operation .
Figure 41
Cylinder Base Hydraulic Connection
Cylinder Rod Hydraulic Connection
Figure 42
Hydraulic Connection to
Left Side Cylinder Bases
Hydraulic Connection to
Right Side Cylinder Bases
Hydraulic Connection to
All Cylinder Rods
MAINTENANCE
7” Average
6”
8”
Front
Cylinder
Rear
Cylinder
Front Cylinder Height: 6”
Rear Cylinder Height: 8”
Total Height: 14”
# of Cylinders: 2
Average Height Calculation
14“ ÷ 2 = 7”
Figure 43