BALZER ELIMINATOR VACUUM TANK Series, User Manual

Page: 36 / 58

32 Eliminator Vacuum Tank (Tandem) User Manual
MAINTENANCE
PTO Shaft Lubrication Specifications
Lubricate all fittings (Figure 39) with a quality EP lithium grease meeting the NLGI #2 specifications and containing no more
than 1% molybdenum disulfide (ex . Shell Super Duty or equivalent) .
An EP lithium grease meeting the NLGI #2 specification and containing 3% molybdenum disulfide may be substituted for the
telescoping members only .
Grease Recommendations
Location Interval Amount
Cross and Bearing Daily 1 Pump ea .
Telescoping Shaft Daily 4-8 Pumps
Replacement parts must be lubricated at time of assembly . Use the amount of grease listed above per location then follow lube
recommendations above for lubricating intervals .
Lubrication
Lubricate with approved quality grease daily before starting work (Figure 32) .
Clean and grease the implement input driveline before each prolonged period
of non-use .
Telescoping members must have lubrication to operate successfully regardless
if a grease fitting is provided for that purpose . Telescoping members without
fittings should be pulled apart and grease added manually to the inside of the
outer telescoping member (Figure 40) .
For any additional maintenance of the PTO shaft, please refer to the
manufacturer’s book that came with the PTO shaft .
DANGER
REPLACEMENT PARTS ARE NOT LUBRICATED! Proper
lubrication must be done at time of assembly.
Figure 40
Figure 39
Grease Point for Implement-Side
Cross and Bearing Grease Point for Shaft Grease Point for Tractor-Side
Cross and Bearing