BALZER ELIMINATOR VACUUM TANK Series, User Manual

Page: 32 / 58

28 Eliminator Vacuum Tank (Tandem) User Manual
Daily and Before Start of Season
Before Starting Tractor
1 . Check tires for damage and proper air pressure . Repair or replace as needed . Tire air pressure should be as listed in
Figure 28 below (for future reference check the box next to the tires on your machine) :
2 . Torque all lug nuts to 450 ft/lbs (before first use after purchase, daily for the first five [5] days, before first use of season,
and after replacing tires) .
3 . Inspect suspension system for damage . Repair or replace as needed .
4 . Inspect all hoses, connections, and reservoirs for leaks . Repair or replace as needed .
5 . Check all oil and fluid reservoirs for proper levels . Fill to proper level with the oil or fluid approved for that system .
The oil level in the vacuum pump must not go below the minimum amount shown in the site gauge (Figure 29) . If it
does, damage to the pump will occur and total pump failure may occur . See “Vacuum Pump” on Page 37 for full
maintenance of the pump . If the oil reservoir on the slurry pump needs oil, fill until the oil is in the middle of the site
glass (Figure 30) .
6 . Inspect all moving components for damage or excessive wear . Repair or replace as needed .
7 . Check braking system for damage or excessive wear . Repair or replace as needed .
MAINTENANCE
Tire Description Tire Pressure
o
28L X 26 R3 - 10 Bolt, 13 3/16” Bolt Circle 26 (180 kPa)
o
28LR26 R3 - 10 Bolt, 13 3/16” Bolt Circle 54 (372 kPa)
o
30 .5x32 R1 - 10 Bolt, 13 3/16” Bolt Circle 33 (228 kPa)
o
30 .5x32 R3 - 10 Bolt, 13 3/16” Bolt Circle 33 (228 kPa)
o
30 .5LR32 R1 - 10 Bolt, 13 3/16” Bolt Circle 52 (359 kPa)
o
30 .5LR32 R3 - 10 Bolt, 13 3/16” Bolt Circle 52 (359 kPa)
o
850/50 30 .5 - 10 Bolt, 13 3/16” Bolt Circle, 10 Ply 37 (256 kPa)
o
900/60 32 R1 - 10 Bolt, 13 1/4” Bolt Circle 35 (241 kPa)
R3 - Diamond R1 - Lug
Figure 28
CAUTION
Before performing any maintenance on this machine,
turn off the tractor, remove the ignition key, and
relieve hydraulic pressure from the hydraulic systems
unless otherwise noted.
WARNING
Using oils and fluids other than those approved and
specified for each system may result in damage to the
machine.
Figure 30
Site Glass
Figure 29
Minimum Level