baltur TBG 1600 MC, Installation, Use And Maintenance Instruction Manual, Page: 59 / 72

ENGLISH
23 / 34
0006160218_201701
MAINTENANCE
Analyse combustion gases and check that the emission values
are correct at least once a year, in compliance with current law.
• Clean air dampers, the air pressure switch with pressure port
and the relevant pipe (if fitted).
• Check the electrode condition. Replace them, if necessary.
• Have the burner and the chimney cleaned by specialised per -
sonnel (stove repairer); a clean burner is more efficient, lasts
longer and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from deposits
deriving from the installation environment and/or from poor
combustion.
• In order to clean the combustion head, its outlet and compo -
nents must be disassembled. Be careful during the reassembly
operations to exactly centre the gas diffuser with respect to the
electrodes, making sure that they are not earthed, which would
result in the locking of the burner. Verify also that the ignition
electrode spark takes place exclusively between itself and the
perforated sheet metal disk (see combustion head and elec -
trode disk distance regulation diagram) for the version without
pilot.
• Analyse combustion gases and check emissions values.
If it is necessary to clean the combustion head, remove its compo -
nents according to the procedure described below:
• Release the tie rod -15 from the lever of the gas flow rate regu -
lation throttle valve -26;
• Unscrew the anchoring screws -11, and open the ventilating
body;
• pull out the ignition and ionisation cables -14 from their elec -
trode terminals-13;
• Unscrew the screw -16 on the buffer -17;
• pull out the entire mixer unit in the direction shown by the arrow.
• Having completed the maintenance work, replace the combus -
tion head, following in reverse order the operations described
above, after having checked the correct position of ignition and
ionisation electrodes.
26
7
8
0002938910
15
34
6