baltur LC3, Manual Instructions For Use

Page: 31 / 116

13 / 16
0006160005_201502
ENGLISH
FOR TBML ... MC
Fig. 2 Fig. 1 Fig. 3
• Remove the synoptic panel (2) from the support after having
removed the fastening screws;
• remove the connectors (3) to completely free the synoptic panel
as shown in figure 1;
• engrave with the help of a blade the rectangular shape of the
screen printing;
• take off the panel part, intended for the regulator, which has
been pre-trimmed as shown in figure 2;
• insert the regulator (6) in the rectangular hole and block it by
means of adjusting screws (7) supplied with the device;
• reposition the synoptic panel by following the inverse order;
• connect the 4-pole connector (M) to the corresponding socket
and the three wires of the cable (L) to the equipment terminals
as shown in figure 3. To ensure proper wiring, refer to the wiring
diagram supplied with the burner;
• connect cables marked with 70 - 71 from the regulator the
relevant terminals.