baltur 20080010, Instruction Manual For Installation, Use And Maintenance

Page: 59 / 66

ENGLISH
59 / 64
0006160045_201802
MAINTENANCE TIME
Part description Action to be performed Fuel Oil
COMBUSTION HEAD
ELECTRODES
VISUAL INSPECTION OF THE INTEGRITY OF CERAMICS. TIP GRINDING,
CHECK DISTANCE, CHECK ELECTRICAL CONNECTION
YEARLY
FLAME DISC INTEGRITY VISUAL CHECK FOR ANY DEFORMATIONS, CLEANING, 6 MONTHS
COMBUSTION HEAD
COMPONENTS
INTEGRITY VISUAL CHECK FOR ANY DEFORMATIONS, CLEANING, 6 MONTHS
LIQUID FUEL NOZZLES REPLACEMENT 6 MONTHS
INSULATING GASKET SEAL VISUAL INSPECTION AND POSSIBLE REPLACEMENT YEARLY
AIR LINE
AIR GRILLE/DAMPERS CLEANING YEAR
AIR DAMPER BEARINGS GREASING, (Note: apply only on burners with bearings requiring lubrication) YEAR
FAN FAN AND SCROLL CLEANING, DRIVE SHAFT GREASING YEAR
AIR PRESSURE SWITCH CLEANING YEAR
AIR PRESSURE PORT
AND PIPES
CLEANING YEAR
SAFETY COMPONENTS
FLAME SENSOR CLEANING YEAR
VARIOUS COMPONENTS
ELECTRIC MOTORS COOLING FAN CLEANING, BEARING NOISE CHECK YEAR
MECHANICAL CAM
CHECK OF WEAR AND OPERATION, GREASING OF SLIDING BLOCK AND
SCREWS
YEAR
LEVERS/TIE-RODS/BALL
JOINTS
CHECK OF ANY WEAR, COMPONENT LUBRICATION YEAR
ELECTRICAL SYSTEM CHECK OF CONNECTIONS AND TERMINAL TIGHTENING YEAR
FUEL LINE
HOSES REPLACEMENT 5 YEARS
PUMP FILTER CLEANING YEAR
LINE FILTER FILTERING ELEMENT CLEANING / REPLACEMENT YEAR
OIL TANK FILTER CLEANING WITH COLD FUEL OIL YEAR
OIL PRE-HEATER CLEANING, CONDENSATE DRAIN FROM LOWER CAP TO COLD FUEL OIL YEAR
COMBUSTION PARAMETERS
CO CONTROL COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP YEAR
CO2 CONTROL COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP YEAR
BACHARACH SMOKE INDEX
CONTROL
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP YEAR
SMOKE TEMPERATURE
CONTROL
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP YEAR
DELIVERY/SCAVENGE OIL
PRESSURE CONTROL
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP YEAR
IMPORTANT
In case of heavy-duty operation or when using special fuels, the maintenance intervals must be reduced adapting them to the real
operating conditions, according to the indications of the maintenance technician.