2.3.
INSTALLATION
•
Product should be leveled using the adjustable legs. Adjust the legs to achieve the required
height and level the product horizontally. Fasten the legs with counter nuts.
•
Fill in the spaces between the product and the wall with silicone sealant if necessary.
•
In the case the product is walled into the bathroom it is important to allow the maintenance of
the product and, where necessary, its removal. When walling up a product, leave a sufficient
ventilation space into the wall.
2.4.
WATER CONNECTION REQUIREMENTS
•
Products drainage tube should be connected with the drainage system with flexible hose.
•
Product has drainage tube with diameter of 40 mm.
•
The product’s drainage system is designed for connecting to self flowing household drainage
system. The drainage rate corresponds to standard drainage rate of bathtubs and shower
cabins drainage rate - 0,9 l/sec. Drainage tubes must be designed and installed with tilt that
guarantees self cleaning of the drainage tubes – i = 0,02…0,03.
•
PS! While installing a bath mixer, connect the mixer with earthing bars of the product’s frame,
using wire of 2,5 mm² of cross section.
•
When installing a bath mixer to a bath which has a massage system (S11), make sure to install
the mixer with a bath frame ground terminal using a protected copper wire with a 2,5 mm
2
, or
larger, cross-section.
3.
MAINTAINANCE
Xonyx™ solid surface baths and shower trays are finished with a silky surface finish. Xonyx™ is a very
durable product that will last for years with simple care. Follow the recommendations below to
properly clean Xonyx™ solid surface product.
3.1.
EVERYDAY CARE
•
It is recommended to clean the bathtub/shower cabin immediately after every use with
thorough rinse of warm water and dry with soft and dry cloth to avoid water stains.
•
Washing with soap or hand dishwashing liquid and water is usually sufficient to remove surface
dirt or stains.
•
Upon need of thorough cleaning wide variety of bath cleaning sprays sold with safety labelling
allowing the cleaning of such surface or commercially available solid surface cleaners are
effective.
•
Drying is an important step, preventing a build-up of soap film or cleaning residue, which can
create the appearance of light scratches over time.