Bally Modularm 75 Installation & Operating Instructions Manual Download Page 3

MODULARM CORPORATION
61 MALL DRIVE, COMMACK, NY   11725

TEL 631-864-3860 ∙ FAX 631-864-3863

TABLE OF CONTENTS

MODEL 75 & 75B GENERAL DESCRIPTION . . . . . . . . . . . . . . . . . .. . . . . .. . . . . 1

CONTROLS, INDICATORS & FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

INSTALLING THE ALARM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

SETTING UP THE ALARM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . 3

OPERATING SEQUENCE OF ALARM  . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . 4

CALIBRATION  . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . .   . . . . . . . . . . . . . . . . . .  4

MODEL 75C CONTROL INSTRUCTIONS . . . . . . . . . .. . . . .  . . . . . . . . . . . . . . .  5
 
SPECIAL OPTIONS  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . . . . . . . . . . .  6

SAMPLE SPECIFICATION MODEL 75 & 75B  . . . . . . .. . . . . .  . . . . . . . . . . . . . . 6

WIRING DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . .. . . . . . . . . . .  . .7

MODEL 75 & 75B GENERAL DESCRIPTION

The   Modularm   Model   75   Temperature   Monitoring   System   is   designed   to   constantly 
monitor temperature and will provide audible, visual and remote notification whenever 
refrigeration failure occurs.  The basic operation of the Model 75 is described as follows:

Through the use of an electronic temperature probe the ambient temperature of a walk-
in cooler or freezer or other temperature sensitive environment is constantly monitored. 
When the monitored temperature goes above or below the temperature setpoints an 
electronic time delay circuit is activated.  The purpose of the time delay is to override 
defrost cycles and other short term changes in temperature that occur during normal 
operation.  When temperature in the monitored area exceeds the setpoints beyond the 
length   of   the   time   delay   the   alarm   activates,   providing   audible,   visual   and,   if   so 
connected, remote notification that an alarm condition has occurred.

(Note 1):  The Model 75 offers Battery Backup as an option.  (75B)  When so ordered, 
the Model 75B will also annunciate any power failures which may occur.

(Note 2):   The Model 75 offers Thermostatic Control as an option. (75C)   When so 
ordered, the Model 75C will provide electronic temperature control.

-1-

Summary of Contents for Modularm 75












Reviews: