Balluff LD2-T048-03-S75, User Manual

Page: 27 / 144

www.balluff.com 5 english
2.1 Intended use
The inductive positioning system BIP with IO-Link
interface, together with a machine controller (PLC) and an
IO-Link master, comprises a positioning/displacement
measurement system. It is intended to be installed into a
machine or system and used in the industrial sector.
Opening the position measuring system or non-approved
use are not permitted and will result in the loss of warranty
and liability claims against the manufacturer.
2.2 General safety notes on the distance
measuring system
Installation and startup may only be performed by
trained specialists with basic electrical knowledge.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allows him to assess the work
assigned to him, recognize possible hazards and take
appropriate safety measures.
The
operator
is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the linear encoder system will not result in
hazards to persons or equipment.
If defects and unresolvable faults occur in the transducer,
take it out of service and secure against unauthorized use.
2.3 Explanation of the warnings
Always observe the warnings in these instructions and the
measures described to avoid hazards.
The warnings used here contain various signal words and
are structured as follows:
SIGNAL WORD
Type and source of the hazard
Consequences if not complied with
►
Measures to avoid hazards
The individual signal words mean:
NOTICE
Identifies a hazard that could
damage or destroy the
product .
DANGER
The general warning symbol in conjunction with the
signal word DANGER identifies a hazard which, if not
avoided, will certainly result in
death or severe injury
.
2.4 Disposal
►
Observe the national regulations for disposal.
2
Safety
BIP LD2-T_ _ _-03-S75
Inductive Positioning System